1 x 210W Monocrystalline Panel. 1 x 20A PWM Solar Charge Controller. 1 x 10FT 12AWG Solar Panel Cable to Charge Controller. 1 x 6FT 12AWG Cable, Charge Controller to LiFePO4 Battery. Note: When setting up your system, the panels should be out of the sun or covered for safety reasons.
Step 1: Connect the Battery to the Charge Controller First. Connect the negative/- cable to the battery terminal on the charge controller. Then connect the positive/+ cable to the battery terminal on the charge controller. Make sure to screw in the exposed wire tightly inside the controller terminal.
Then screw on the battery rings to the battery. Step 2: Connect the Solar Panel to Charge Controller Second?????? Connect the male/black wire of our solar cable to the female/- cable from the solar panel, and then connect the extended cable to the - solar terminal on the charger controller.
Then connect the female/red wire of our solar cable to the male/+ cable from the solar panel, and then connect the extended cable to the + solar terminal on the charge controller. This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Solar Power Supplies\Solar Panels & Kits". The seller is "expertbattery" and is located in this country: US.This item can be shipped to United States.